Jump to content

wrcrs24

Member
  • Posts

    16
  • Joined

  • Last visited

wrcrs24's Achievements

0

Reputation

  1. Not sure about the escape but in the fusion has 2 signal modes momentary (3 flashes) and constant. Pushing up or down accordingly past the 1st resistance point sets it to constant.
  2. https://www.youtube.com/watch?v=IqRhQHlmsTc
  3. I've mentioned it 3 times at my dealer and they just brush it off. Not too happy with how they deal with customers.
  4. Looks good! I have been eyeing these for a while now. Might have to pull the trigger and get a set.
  5. I can only fit 13 when I run it down to E 2.0, eco here
  6. How do they look when they aren't lit up
  7. Found the issue after a little trouble shooting LOC was bad so i replaced it. Big fan of the pdx amps going to run a pdxv9 in the future just had the mono sitting around and wanted to test it out.
  8. connected to the rear speakers behind the dash
  9. Looking for some input with using a LOC. I've got everything hooked up and buttoned back up. And at the point where I am fine tuning the sub but it sound horrible. My amp is a alpine pdx1.600 and my sub is a Si bmkIV. I was using a similar setup in my ford f150 with a aftermarket double din and I'm wondering if that is what made the difference (due to eq settings).
  10. Looking for an answer on this as well..... Or I might tackle it if nothing comes up soon.
  11. Didn't need the actual coupon just mentioned that I should have it and they were able to look it up!
×
×
  • Create New...