Jump to content

Mpollard

Member
  • Posts

    18
  • Joined

  • Last visited

Everything posted by Mpollard

  1. Yes chains were right. I’m going to use the cheese wedge thing and change the phasers if that’s not it I guess I’ll dig back in and check timing
  2. What are chances of the bad phaser
  3. I can also unplug the solenoids and cam sensors with no change in running. Oil pressure on gauge actually shows a little high
  4. I took the back of the phasers off to look for broken vanes inside. Leaving one screw in that holds apring tension The chains had three black links in them. When I took it apart it had blew a head gasket. I put 12 volts on the vvt solenoid and it moves free. The phaser is the only thing I can think of. Since it was showing this code before and after. Would a bad phaser on passenger side make it run rough at idle and be hard to start? When I turn the phaser bolt the front of the phaser will turn a little. Is that normal? I just don’t want to tear it down change phaser and then have to do it again to time it again
  5. My 07 expedition had code p0016 in it. I tore it down put new chains guides and tensioners in it put it back together fires it up and still has this code. I swapped cam sensors and vct solenoids but still has code. Hard to start and rattles when started for a second. Could this be phasers? It idles rough too
×
×
  • Create New...